Explaining The Power States - Barco Freya User Manual

Getting started

2.1 Explaining the power states

Power states explained
The projector can have one of several power states, which you can recognize by the state of the power LED.
Projector
Behavior
Power State
Mains power off Projector is not powered
OFF mode The power button and GPI3 are powered (for remote power-on).
ECO mode Projector IP connection is active; touch display and image processing
are off.
READY mode Projector is fully powered and active; touch display is on (if available),
Web Communicator is active and light is OFF.
ON mode Projector is fully powered and active; touch display is on (if available),
Web Communicator is active and light is ON.
Going to ECO Turning electronics and light source OFF.
mode
1
Image 2–1
1 Mains power off
2 OFF mode
3 ECO mode
Switching between power states
You can change power state by using one of the following options:
• Pressing the Power button on the Cinema Controller (reference 1)
• Sending a wake-up signal to the GPI3 input for more than 0.5 seconds, but less than 2 (reference 2).
• Using the ECO menu on the touch display (if available).
• Using the Power menu in Web Communicator.
1. GPI3 works the same way as the power button. Thus take into account that sending a signal for more than 6 seconds will turn the
projector OFF instead.
28 R5910032 /00 Freya
2 3 4 5
4 READY mode
5 ON mode
6 Going to ECO mode
Power LED
Off
Slowly blinking
RED
Full RED
Full GREEN
Full GREEN
Blinking green
6
1