Editing A Screen File - Barco Freya User Manual

Set the position the 4 corners manually by using arrows (reference 13):
1. Click on a corner (e.g. reference 11) to select it, then use up/down/left/right arrows (reference 13) to
reach the desired position.
2. Redo the same operation with the other corners.
5. Set the 4 sides alignment by using numeric values. Fit the four sides of the picture to the four sides of the
screen by blanking the pixels displayed outside of the screen. This setting is mainly used on curve
screens.
1. Click on the input field of the Top curve (reference 7) and enter the curve factor (or use up down control
of spin box near the input field).
2. Redo the same operation with the other curves: Right curve (reference 8), Bottom curve (reference 9),
Left curve (reference 10).
or
Set the 4 sides alignment manually by using arrows (reference 13):
1. Click on a side/curve (e.g. reference 12) to select it, then use up/down/left/right arrows (reference 13)
to reach the desired position.
2. Redo the same operation with the other side/curves.
6. Click Discard (reference 15) allows to remove all the modifications done in the previous steps.
7. Click Restore (reference 16) allows to reset the masking (zero position).

7.7.4 Editing a Screen file

Location & access
Menu: Configuration > Projector > Picture
Level: Administrator, Service technician
How to edit
1. While in Configuration > Projector > Picture, find and click on the screen file you want to edit.
The screen file is displayed in its expanded form with menu.
Image 7–137
2. Click Edit in the menu.
Configuration - Projector
R5910032 /00 Freya 155