Table of Contents
Advertisement
Setting Up Cutting by Layer
Setting item
*2
[Mode / Tool]
*1
This synchronizes with [Color No.] in the dialog when [Color] is clicked.
*2
When Cutting mode is selected, settable parameters and [Material] are displayed.
*3
When this mode is selected, the order of output layers cannot be set manually.
5.
Set [Material] ( ) and parameter ( ).
If there is no option to select for [Material], click
ue to edit it.
MEMO
• Enter 1 in [Step count]. Entering a value other than 1 sets up overlap cutting.
• If [Defalut] is selected from the [Mode / Tool] list, the parameters set in the [Output to device] window
are applied, so parameters are not set here.
Layers with their output settings configured are marked with a red check mark next to them.
6.
Click [OK] to close the [Layer Settings] window.
100
Using GreatCut-R
Settings
[Defalut]
[Cut]
[Cut with AAS]
[FlexCut]
Notes
[Defalut]: The parameter values set in the [Output to
device] window are applied.
[Cut]: Set to cutting only
[Cut with AAS]: Set to printing and cutting
[FlexCut]: Set to perforated cutting
to add materials. Click the parameter val-
*3
Advertisement
Table of Contents
