Table of Contents
Advertisement
8.
Move the pinch rollers and place them on both edges of the roll material.
Check that the pinch rollers are positioned within the range of the grit patterns. If the pinch
rollers are not placed within the range of the grit patterns, the material cannot be fed proper-
ly.
Position the pinch rollers on the edges so that each one is 0.5 to 25 mm (0.02 to 0.98 in.) (if
the roll material used is more than 4 m [157.49 in.] long, then more than 25 mm [0.99 in.])
inside of the respective left or right edge of the material.
9.
When loading material that lifts up easily, place the pinch rollers on the middle of the material.
Individually raise pinch rollers that are not in use.
10.
Lower the lever.
The material is secured in place.
Loading the Material
Basic Settings and Operations
25
Advertisement
Table of Contents
