Prioritizing The Cutting Settings Of This Machine - Roland Camm-1 GR2-640 User Manual

Configuring and Viewing Environment Settings

Prioritizing the Cutting Settings of This Machine

The cutting settings on the operation panel can be prioritized over the printer driver settings. For cut-
ting settings (blade force, speed, quality, and offset), the printer driver (or GreatCut-R/VersaWorks)
settings are usually prioritized.
Procedure
1.
Press [TOOL SELECT].
If material is loaded, press [ON/OFF LINE] to switch to offline mode.
2.
Press [▶] several times to display the screen shown below.
Panel Setup
Select:
3.
Press [ENTER].
4.
Press [▲] or [▼] to select "Control panel only".
This setting prioritizes the cutting conditions set up on the operation panel over the printer
driver settings. If this is set to "Accept setup command", the printer driver (or GreatCut-R/
VersaWorks) settings are prioritized.
Control panel only
Change:
5.
Press [ENTER] to confirm your entry.
6.
Press [ON/OFF LINE] to go back to the original screen.
MEMO
Default setting: "Accept setup command"
18
Basic Settings and Operations
OK:ENTER
OK:ENTER