Performing a Cutting Test
Check item
Peel off the pat-
tern
Pattern shape
10.
If the appropriate result is not achieved, adjust the necessary settings.
P. 39 "Adjusting the Cutting Conditions"
11.
After adjusting the settings, press [ENTER].
The test pattern is cut again. Repeat steps 9 through 11 until an appropriate cutting result is
obtained.
12.
Press [ON/OFF LINE] twice to switch to online mode.
RELATED LINKS
・ P. 36 "Recommended Cutting Conditions"
・ P. 112 "Adjusting the Cutting-in Amount"
38
Preparations before Cutting Output
Result
Two shapes peel off separately/Cross cutting lines are cut
Two shapes peel off together/Cross cutting lines are not
cut
Some uncut areas remain.
Carrier paper is also cut
Corners are not rounded and do not
have horns
Corners are rounded
Corners have horns
The cut shape is distorted.
Setting item
Adjustment
Appropriate
Cutting force
Increase
Cutting speed
Reduce
Cutting force
Reduce
Appropriate
Blade offset
Increase
Blade offset
Reduce
Cutting speed
Reduce