Table of Contents
Advertisement
Loading the Material
4.
Place the roll material in the roll holder.
• When using the roll holder flanges, place them in the center of the grooves on the roll
holder guide bushes to prevent these flanges from interfering with the sides of these
grooves. This interference may lead to misaligned material due to lopsided material feed-
ing.
• If roll holder flanges are not used, place the roll material between the two roll holders and
the front, back, left, and right roll holder guide bushes. When placing the damper-equip-
ped roll holder in notches up to the second set of notches on the machine side of the roll
holder supports, remove the roll holder guide bushes from this roll holder.
When roll holder flanges are used
5.
Tighten the resin bolts of the roll holder guide bushes.
IMPORTANT
To evenly distribute the weight of the roll holder's rotation shaft during roll material feeding, place the resin
bolts of the roll holder guide bushes on the machine side and the front side facing 180 degrees opposite of
each other as shown in the pictures.
6.
Check that the lever is raised.
If the lever is lowered, raise the lever.
7.
Pass the front end of the roll material between the pinch rollers and the grit rollers from the rear
side of the machine ( ) and pull it straight out to above the platen ( ) using the scale of the rulers
(in two locations: one on the top and one on the bottom) as a guide.
Feed the material so it is slightly longer than necessary, leaving some slack.
24
Basic Settings and Operations
When roll holder flanges are not used
Advertisement
Table of Contents
