Setting The Aas Detection Mode - Roland Camm-1 GR2-640 User Manual

Setting the AAS Detection Mode

Normally the crop mark origin is set at the front right, facing the machine, but when crop marks are
set up using the AAS plug-in, you can specify the reading direction of the crop marks for the loaded
material.
Procedure
1.
Press [MISC].
If material is loaded, press [ON/OFF LINE] to switch to offline mode.
2.
Press [▶] to display the screen shown below.
AAS detect mode
Select:
3.
Press [ENTER].
The current setting is displayed.
4.
Press [▲] or [▼] to set the material detection mode.
Auto detection
Change:
Reverse derection
Change:
Forward derection
Change:
5.
Press [ENTER].
6.
Press [ON/OFF LINE] to go back to the original screen.
MEMO
Default setting: [Auto detection]
RELATED LINKS
・ P. 62 "Automatic Detection of Material Feed Direction"
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
Automatic Detection of Material Feed Direction
Detect upon rotating (by 180 degrees) according to the
orientation of the crop marks printed on the material
Detect from reverse direction (rear)
Detect from front
Basic Printing and Cutting
63