Table of Contents
Advertisement
Setting Up Overlap Cutting on the Operation Panel
Using the operation panel, you can repetitively cut a preceding cutting job sent to the cutting ma-
chine.
MEMO
• To send jobs from the printer driver, open the [Printing Preferences] window, and then select the [Back to Home]
check box.
• To send jobs from GreatCut-R, open the [Output to device] window, and then set [Origin] to [Don't set].
Procedure
1.
Load the material and measure its size.
P. 21 "Loading the Material"
2.
Press [ON/OFF LINE] to switch to offline mode.
3.
Press [CUT TEST].
4.
Press [▶] several times to display the screen shown below.
Redo Jobs in Memory
Select:
5.
Press [ENTER].
The current value is displayed on the screen.
Recut
Select:
6.
Press [▶] to select [Recut].
7.
Press [▲] or [▼] to select the number of repetitions.
8.
Press [ENTER].
Cutting starts. If you set the repetition count to 2 or higher, a confirmation message will ap-
pear at the end of the job, asking whether you want to execute the next job. Press [PAUSE/
RESUME] to execute the next job.
9.
When the cutting is finished, press [ON/OFF LINE] to go back to the original screen.
RELATED LINKS
・ P. 109 "Setting Overlap Cutting Using the Printer Driver"
・ P. 54 "Sending Cutting Jobs from GreatCut-R"
OK:ENTER
# 1
OK:ENTER
Dealing with Material Thickness/Hardness (Softness)
Optimizing the Output Quality
111
Advertisement
Table of Contents
