Table of Contents
Advertisement
Security Escort
[Previous]
[Next]
[Cancel]
4.3.8
Receiver configuration dialog
Once the receiver and alert unit data for a transponder has been entered into the
Transponder Database, this dialog is used to verify that each receiver is working and is
properly addressed in the database. This setup tool identifies errors in the address switch
settings of receivers and alert units as well as data entry errors in the Transponder Database.
Figure 4.41: Receiver Configuration Dialog
[Put this receiver in setup
mode]
Bosch Security Systems B.V.
Returns to the previous transponder in the system.
Advances to the next transponder in the system.
Cancels the operation and closes the dialog window.
This button initiates the setup process by causing both the
red and green LED of the selected receiver to light up. The
red and green LED will be flashing. On the Central Console,
this button changes the [Abort setup for this MUX Point]
button to be able to proceed to the next device in the event
that one receiver is not set up properly.
Technical Reference Manual
System menus and screens | en
2019.08 | V2.18.1.6 | DOC
81
Advertisement
Table of Contents
