Table of Contents
Advertisement
Security Escort
Figure 4.6: Blank Dialog Resulting from Selection of [Insert New] Button
The new elements of the Edit Transponder's Database Record dialog.
Trouble Type Text
Trouble Tamper Text This is the text that will be shown in the trouble dialog when the
Trouble Response
Text
Show Points
Show Areas
Setting receivers parameters
Create or modify the receivers of the transponder using the features of the Point or Area
Data. For configuring Area Data, refer to the Alarm area setup section. The sections below
explain how to configure the receiver points for the transponder.
Bosch Security Systems B.V.
This is the text that will be shown in the trouble dialog when the
remote key input on the transponder goes active (shorted).
remote key input on the transponder goes into trouble (open).
This is the text that will be shown in the trouble dialog as the response
test. The actions the responding individual should take.
If selected, the lower section of the Transponder Database dialog will
show the point's (receiver, virtual receiver or alert unit's) database
values.
If selected, the lower section of the Transponder Database dialog will
show the alarm area's database values.
Technical Reference Manual
System menus and screens | en
2019.08 | V2.18.1.6 | DOC
27
Advertisement
Table of Contents
