Bosch Security Escort SE2000 Series Technical Reference Manual page 146

146 en | Maintenance
<Area AreaID="0" FloorIcon="9" PagerGroupA="0" BitmapNumber="0"
LocationText="1st Floor Main Lobby Area" MatrixSwitchText="">
<ProtectedAreaPoints ProtectedXArea1="386"
ProtectedYArea1="292" ProtectedXArea2="386" ProtectedYArea2="292"
ProtectedXArea3="385" ProtectedYArea3="209" ProtectedXArea4="470"
ProtectedYArea4="209" ProtectedXArea5="468" ProtectedYArea5="297"
ProtectedXArea6="387" ProtectedYArea6="294" />
</Area>
<Area AreaID="1" FloorIcon="9" PagerGroupA="0" BitmapNumber="0"
LocationText="1st Floor Main Entrance &amp; Accounting Area"
MatrixSwitchText="">
<ProtectedAreaPoints ProtectedXArea1="385"
ProtectedYArea1="293" ProtectedXArea2="385" ProtectedYArea2="293"
ProtectedXArea3="468" ProtectedYArea3="297" ProtectedXArea4="470"
ProtectedYArea4="351" ProtectedXArea5="384" ProtectedYArea5="348"
ProtectedXArea6="386" ProtectedYArea6="294" />
</Area>
</Areas>
</Transponder>
<Transponder TransponderID="1" Name="South Point Hospital"
IsIPConnected="0" IPAddress="" PortNumber="0" CommPortIndex="0">
<Receivers>
<Receiver Address="6" PointType="0" AlgoNumber="0" AlarmIcon="9"
Rx_LocationText="1st Floor by South Exit Door" MapXPosition="430"
MapYPosition="479" SensitivityAdjust="0" BitmapNumber="0"
RSSIOffset="-10" />
<Receiver Address="7" PointType="0" AlgoNumber="0" AlarmIcon="9"
Rx_LocationText="1st Floor Center of Main Lobby" MapXPosition="429"
MapYPosition="215" SensitivityAdjust="0" BitmapNumber="0" RSSIOffset="0" />
</Receivers>
</Transponder>
The following attributes are applicable to the respective elements.
<Transponder> element
Attribute
TransponderID
Name
IsIPConnected
IPAddress
PortNumber
2019.08 | V2.18.1.6 | DOC
Value
ID of the transponder. 1-255. This field should contain only
numeric ASCII characters.
Name of the transponder. This field may be up to 24 characters.
This field may contain any printable ASCII character except the '?'
0 if transponder is connected via RS232, 1 if transponder is
connected via TCP IP. This field should contain only numeric
ASCII characters.
The value is blank if IsIPConnected is 0 (RS232). The value should
contain a valid IP address if IsIPConnected is 1 (TCP IP).
The value is 0 if IsIPConnected is 0 (RS232). The value is 1-65535
if IsIPConnected is 1 (TCP IP).
Technical Reference Manual
Security Escort
Bosch Security Systems B.V.