Table of Contents
Advertisement
Security Escort
[Reset Transponder]
[Transponder Outputs]
[Point Out Of Service]
[Point In Service]
Horn - Siren
Green LED
Strobe - Red LED
[Off Output Command]
Bosch Security Systems B.V.
by the Central Console. When the transponder has retried
transmitting an "I'm OK" message or any other message six times
without acknowledgment, it assumes control of the outputs
(LEDs, horns, strobes, and sirens) on devices connected to it
and modifies the message to indicate that it is still okay and has
taken control. These messages are transmitted once per minute
until communications are reestablished.
The [I'm OK Check] button requests that the transponder send
an "I'm OK" message. This is used to determine if a transponder
has taken control of its outputs. The [I'm OK Release Control]
button generates a command to the transponder to release
control back to the Central Console. Normally, the Central
Console automatically generates a release control message upon
the re-establishment of communications following a failure.
Clicking this button resets the transponder as if it was just
powered up. Any test or alarm processing that was in progress at
the time is lost.
Requests the current state of the siren and strobe outputs on
the transponder.
Clicking this button takes the currently selected point out-of-
service. That point no longer responds to the system, as if it was
disconnected. Use this function with caution.
Clicking this button restores the currently selected point to an
in-service condition. That point returns to normal function.
If this checkbox is checked, the horn output of a receiver or the
siren output of an alert unit is turned on if the [On Output
Command] button is clicked, or off if the [Off Output
Command] button is clicked. If this checkbox is not checked, the
state of this output is not changed.
If this checkbox is checked, the green LED output of a receiver
or the spare output of an alert unit is turned on if the [On
Output Command] button is clicked, or off if the [Off Output
Command] button is clicked. If this checkbox is not checked, the
state of this output is not change.
If this checkbox is checked, the red LED output of a receiver or
the strobe output of an alert unit is turned on if the [On Output
Command] button is clicked, or off if the [Off Output
Command] button is clicked. If this checkbox is not checked, the
state of this output is not changed.
When clicked, the checked horn-siren, green LED and strobe-red
LED outputs are turned off for the selected point on the selected
transponder. If the output does not change, click the [On Output
Command] button and then click the [Off Output Command]
button again.
Technical Reference Manual
System menus and screens | en
2019.08 | V2.18.1.6 | DOC
73
Advertisement
Table of Contents
