Table of Contents
Advertisement
72
en | System menus and screens
[Restarted]
[Dropped]
[Horn - Siren Map]
[Green LED Map]
[Strobe - Red LED Map]
[AC Loss]
[Low Battery Map]
[Out Of Service Map]
[I'm OK Check]
[I'm OK Release Control]
2019.08 | V2.18.1.6 | DOC
Requests a map of all the points that are powered up or had a
watchdog failure to the system. The [Restarted] button displays
a map with "1" in the locations corresponding to points that are
restarted.
Requests a map of all the receivers that have dropped one or
more receptions due to high traffic. The [Dropped] button
displays a map with "1" in the locations corresponding to
receivers that dropped one or more transmissions.
Requests a map of all the points that have their horn or sirens
on, on this transponder. The [Horn - Sirens Map] button displays
a map with "1" in the locations corresponding to points which
have their outputs on. A "0" (zero) indicates that the output is
off.
Requests a map of all the points on this transponder that have
their spare outputs - green LED on. The [Green LED Map] button
displays a map with "1" in the locations corresponding to points
which have their outputs on. A "0" (zero) indicates that the
output is off.
Requests a map of all the points on this transponder that have
their strobe - red LED on. The [Strobe - Red LED Map] button
displays a map with "1" in the locations corresponding to points
which have their outputs on. A "0" (zero) indicates that the
output is off.
Requests a map of all the alert units that are currently reporting
an AC power failure to the system. The [AC Loss] button
displays a map with "1" in the locations corresponding to alert
units that are reporting AC loss.
Requests a map of all the alert units that are currently reporting
a low battery to the system. The [Low Battery Map] button
displays a map with "1" in the locations corresponding to points
that are reporting low battery.
The Out Of Service Map shows those points (receivers or alert
units) that are currently out of service. Points may be taken out
of service and returned to service by selecting the point using
MUX Bus Point dialog in the bottom right corner of the screen
and clicking the [Point Out Of Service] or [Point In Service]
button. Points can be selected by typing in the point number or
by using the [+] and [-] buttons, or the [?] button.
These buttons are used to diagnose and correct communications
problems between the Central Console and the transponder. The
system software requires that each transponder send a message
to the Central Console periodically if no other communications
have taken place. These messages are called "I'm OK" messages.
If for some reason the communications link between the Central
Console and the transponder fails, the transponder recognizes
the fact when its "I'm OK" transmissions are not acknowledged
Technical Reference Manual
Security Escort
Bosch Security Systems B.V.
Advertisement
Table of Contents
