Table of Contents
Advertisement
82
en | System menus and screens
Ambient value
Auto Advance
RF micro revision
Horn - Siren
Red LED - Strobe
Green Led
[Off]
[On]
[Antenna]
[Ant map]
2019.08 | V2.18.1.6 | DOC
The Ambient value, shown above Auto Advance, shows the
current ambient level at the receiver. To get an updated
ambient reading, select the point and click the [Transmit]
button followed by the [Ambient] button.
If this checkbox is checked, the Central Console
automatically selects the receiver with the next higher point
address.
The receiver's RF micro revision level is shown below Auto
Advance. To get an updated reading, click the [Revision]
button.
If this checkbox is checked, the horn output of a receiver or
the siren output of an alert unit is turned on upon clicking
the [On] button, or turned off upon clicking the [Off]
button. If this checkbox is not checked, the state of this
output does not change.
If this checkbox is checked, the red LED output of a receiver
or the strobe output of an alert unit is turned on upon
clicking the [On] button, or turned off upon clicking the
[Off] button. If this checkbox is not checked, the state of
this output does not change.
If this checkbox is checked, the green LED output of a
receiver or the spare output of an alert unit is turned on
upon clicking the [On] button, or turned off upon clicking
the [Off] button. If this checkbox is not checked, the state
of this output does not change.
Upon clicking the button, any checked outputs (Horn-Siren,
Green LED, Red LED - Strobe) is turned off for the selected
point on the selected transponder. If the output does not
change, click the [On] button followed by the [Off] button
again.
Upon clicking the button, any checked outputs (Horn-Siren,
Green LED, Red LED - Strobe) is turned on for the selected
point on the selected transponder. If the output does not
change, click the [Off] button followed by the [On] button
again.
Normally, a receiver automatically switches between its
diversity antennas during normal operation (leave the
default selection on a working system at this setting). The
receiver can be forced to use only the left or right antenna,
or always switch by selecting the appropriate setting and
clicking the [Antenna] button.
Clicking the [Ant map] button causes the system to
interrogate the current antenna switching settings of all
receivers on this transponder.
Technical Reference Manual
Security Escort
Bosch Security Systems B.V.
Advertisement
Table of Contents
