Table of Contents
Advertisement
78
en | System menus and screens
Figure 4.39: Transponder Parameter Change Dialog
Run silent
Optional parameter
Loop communications
Enable remote key(
Uses Proxim radio
Comm fail to siren out
2019.08 | V2.18.1.6 | DOC
If checked, the receivers and alert units on this transponder do not
sound an alarm. This includes alarms received during a
communications failure with the Central Console.
This option is currently disabled and reserved for future use.
Normally the transponders are connected in parallel (party line) so
they can all hear if any other transponders are in communications so
they don't collide when communicating. However if fiber optic
communications is used between the transponders and PC they can't
be connected this way. Therefore they are connected in a loop. The
transmission from the PC goes to the receiver on the first
transponder. The transmission from the first transponder goes to the
receiver on the second transponder and so on, until the transmission
from the last transponder goes to the receiver on the PC. This option
tells the transponders they are connected this way so it can react.
You must make this change to the first transponder first, followed
with the second, continuing in order until all is done.
If checked, the remote key supervised input on this transponder is
enabled. Otherwise it will be ignored.
Only check this item if a Proxim radio is used to communicate to the
Central Console.
If this item is checked, the siren output on this transponder activates
when a communications failure is detected at the Central Console.
Technical Reference Manual
Security Escort
Bosch Security Systems B.V.
Advertisement
Table of Contents
