Receiver Test Dialog - Bosch Security Escort SE2000 Series Technical Reference Manual

84 en | System menus and screens
Figure 4.42: Abort Button to Remove a Device from the Setup Mode
The Central Console also confirms the successful setup with an audible and text message. The
[Abort setup for this MUX point] button disappears and is replaced by [Test on this MUX
point SUCCESSFUL] button. Click this button to conclude the test on this point.
4.3.9

Receiver test dialog

Use this dialog to set up and monitor four receivers, and listen to one receiver transmitting
with its buddy check transmitter. Normally, the function is for engineering evaluation of new
transmitter and receiver designs, but it can be used to test receiver boards and locations in a
working system.
2019.08 | V2.18.1.6 | DOC Technical Reference Manual
Security Escort
Bosch Security Systems B.V.