Table of Contents
Advertisement
96
en | System menus and screens
Figure 4.48: Remote Comm Port Setup Dialog
Network Port
Modem Port
System Serial 1/2
COM
Baud
2019.08 | V2.18.1.6 | DOC
This port connects the master and slave computers of the
Security Escort System. If this system has only a single
computer, this setting should be set to none.
This port typically connects to the modem for remote access
and pager dial out. If set in the Remote Setup dialog, use
this port without a modem for direct connection to a
computer that is always on line.
This is a general-purpose serial port. Its function is set up in
the Remote Setup dialog.
The actual physical communication port over which these
communications are carried.
The speed at which characters are transmitted on this serial
port. This setting must match the baud rate of the device
connected at the other end of this serial connection. This
setting should always be at the highest speed that both
connected devices have in common. Modem connections are
typically much more efficient, if the baud rate is set
Technical Reference Manual
Security Escort
Bosch Security Systems B.V.
Advertisement
Table of Contents
