Adjusting The Media Stop Position - SATO CT4-LX Operator's Manual

Hide thumbs Also See for CT4-LX:

Table of Contents

Adjusting the Media Stop Position

Set the [Offset] in the [Printing] > [Advanced] > [Adjustments] menu to adjust the media stop position

(for cutter/dispenser/tear-off mode).

The above cut position becomes the stop position when the sensor type is set to

transmissive (Gap).

You can also adjust when the print mode is specified to tear-off or dispenser.

1. Tap [SETTINGS] on the Home screen or Offline screen.

2. Input the password if it is enabled.

3. Tap [Printing].

4. Tap [Advanced] > [Adjustments] > [Offset].