SATO CT4-LX Operator's Manual page 260

◦ [All]
◦ [Information]
◦ [Printing]
◦ [Interface]
◦ [Applications]
◦ [System]
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
203 dpi (1 dot = 0.125 mm (0.0049"))
305 dpi (1 dot = 0.083 mm (0.0033"))
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
203 dpi (1 dot = 0.125 mm (0.0049"))
305 dpi (1 dot = 0.083 mm (0.0033"))
When you decrease the setting value, the print position moves in the feed direction.
When you increase the setting value, the print position moves opposite the feed direction.
Offset
Set the tear-off position/cut position/dispense stop position.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
203 dpi (1 dot = 0.125 mm (0.0049"))
Setting range
400 to 1,600 dots
600 to 2,400 dots
Setting range
-30 to +30 dots
-45 to +45 dots
Setting range
-30 to +30 dots
260
[Test Print]