Table of Contents
Advertisement
Can be set if [Auto-mode] is disabled.
The options are as follows:
[Continuous]
Continuously print the specified number of the media. The media remains in position for printing at
all times.
[Tear-Off]
After printing the specified number of media, the product feeds the last printed media so that it
is fully extended out of the product's front for removal. After printing, tear off the media manually.
The media will be back to the print head position for starting the next printing.
[Dispenser]
Peels the liner from the printed label as the label is fed. Once the printed label has been removed
from the product, the next label is positioned for printing.
[Cutter]
Cuts each media while printing the specified number of media.
[Cut & Print]
Allows you to print the next data while the previous data is cut at the end position of the printed
media. If no print data is received within the period specified for [Eject Cut], the product feeds the
media to the cut position and cuts at the end position of the printed media.
[Partial cutter]
Cuts each media leaving a part of the media while printing the specified number of media.
[Linerless cutter]
Media is printed and cut 1 piece at time. Once the cut media has been removed, the next media
returns to the print position.
[Linerless tearoff]
The product feeds each printed media so that it is fully extended out of the product's front for
removal. After printing, tear off the media manually. The media will be back to the print head
position for starting the next printing.
•
Changing the print mode may link to and change [Sensor Type] and [Backfeed]. After
changing the settings, confirm that the settings have become compatible with the
media you are using.
•
When using RFID tags on an RFID model, do not select cutter mode with no backfeed,
partial cutter mode, linerless cutter mode, or linerless tearoff mode. If these print
modes are set, you cannot use RFID tags.
167
Advertisement
Table of Contents
