SATO CT4-LX Operator's Manual page 173

Hide thumbs Also See for CT4-LX:

Table of Contents

Adjusts the Gap sensor.

Adjusts the I-mark sensor.

Adjust the label top sensor.

[Label Top] is not displayed if the optional dispenser unit or linerless cutter unit is

For media that has no liners, such as wristbands and koDakara, [Label Top] cannot be

The procedure to auto-calibrate the media sensor is as follows:

1. Open the top cover.

2. Load the media.

For adjusting [Gap + I-Mark]/[Gap]/[I-Mark]

Remove the label from the liner and set the liner so the I-mark is not above the I-mark sensor.

For media without liners, such as wristbands or journal paper, load the media as is.

For adjusting [Label Top]

Remove the label from the liner and set the liner so the I-mark is not above the label top

3. Close the top cover.

4. Tap the type of sensor from the list to be adjusted.

5. When the confirmation screen appears, tap

If message indicating adjustment failed, load the media correctly and try again.