Table of Contents
Advertisement
2. Prepare the LaserFlow recepta-
cle by removing the cap (press
down on the spring release and
pull out the cap).
3. Remove the cap from the 350
TIENet plug and push the pro-
tective caps of the two sensors
together.
4. Aligning the pins on the Laser-
Flow cable with those in the
connector receptacle, push the
350 connector into the recepta-
cle on the inner wall of the
LaserFlow until the spring
release clicks.
Figure 5-6 Connecting the 350 AV sensor to the LaserFlow
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 5 Maintenance and Optional Kits
5-9
Advertisement
Table of Contents
