Table of Contents
Advertisement
5.7 Installing the Optional
Submerged
Measurement Kit
Tools Required
5.7.1 Installation Procedure
Figure 5-4 350 AV sensor with mounting plate
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 5 Maintenance and Optional Kits
The submerged functionality consists of a TIENet 350 Area
Velocity sensor mounted on the bottom of the LaserFlow sensor.
This option is normally pre-assembled and installed at the
factory before shipment. However, it can also be installed by the
user in existing systems.
To install the submerged measurement kit, you will need:
• Integrated 350 Kit from Teledyne Isco
· TIENet 350 AV Sensor with 28" cable
· Sensor mounting plate
· 2 Flathead screws
· 2 Lock nuts
· 2 Flat washers
1
•
/
" Nut driver or open wrench
4
You must access the LaserFlow's interior to install this option.
Instructions for opening and reassembling the LaserFlow are
provided in Section 5.4 Accessing the LaserFlow's Nose Piece.
Disconnect power from the LaserFlow sensor before
opening the sensor housing.
NEVER touch the window or get it dirty.
WARNING
CAUTION
5-7
Advertisement
Table of Contents
