Remote Ultrasonic Cable Connection; Ultrasonic Sensor; Preparing The Laserflow Connector Receptacle; Secure Caps And Connect 310 Ultrasonic Plug To Laserflow - Teledyne TIENet LaserFlow 360 Installation And Operation Manual

TIENet™ 360 LaserFlow™ Velocity Sensor
Section 2 Preparation and Installation
2.4.2 Remote Ultrasonic
Cable Connection:

310 Ultrasonic Sensor

Figure 2-8 Preparing the LaserFlow connector receptacle
Figure 2-9 Secure caps and connect 310 ultrasonic plug to
LaserFlow
2-8
1. Prepare the LaserFlow connector receptacle by removing
the cap (press down on the spring clip and pull out the
cap).
2. Remove the stainless steel cap from the 310 ultrasonic
plug and push the protective caps from the LaserFlow
module and ultrasonic together.
3. Aligning the pins on the 310 ultrasonic plug with those in
the connector receptacle, push the ultrasonic plug into the
receptacle until the spring release "clicks."
To be certain that the connectors are locked, lightly pull on the
cable connector; the cable should be held in place by the spring
release clip.