Table of Contents
Advertisement
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 4 Setup with 2160 LaserFlow Module
Figure 4-16 350 Velocity tab: Advanced settings for optional TIENet 350 AV sensor
4.3 Sensor Positioning
and Adjustment
4.3.1 Centering the
LaserFlow Sensor
Laser on
4-18
To set the initial level values, refer to Sections 4.2.1 (LaserFlow)
and 4.2.4 (optional 350).
Proper positioning of the LaserFlow sensor is critical for optimal
velocity measurement. In center position, the laser beam must
strike the flow stream precisely in the center.
The beam automatically moves to the top center position.
Select the "Laser on" button and click the "Apply" button. This
will keep the laser beam on continuously for 10 minutes or until
the "Laser off" button is clicked, allowing the beam to be used
for fine-tuning the sensor's position.
Advertisement
Table of Contents
