Table of Contents
Advertisement
2.4.3 Cable Connection:
2160 LaserFlow
Module
Figure 2-10 Preparing the 2160 connector receptacle
Figure 2-11 Secure caps and connect LaserFlow to 2160
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 2 Preparation and Installation
1. Prepare the 2160 receptacle by removing the cap (press
down on the spring clip and pull out the cap).
2. Remove the cap from the LaserFlow TIENet plug and push
the protective caps on the module and sensor together.
3. Aligning the pins on the LaserFlow cable with those in the
connector receptacle, push the sensor connector into the
receptacle until the spring release "clicks."
4. To be certain that the connectors are locked, lightly pull on
the cable connector; the cable should be held in place by
the spring release clip.
2-9
Advertisement
Table of Contents
