Table of Contents
Advertisement
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 2 Preparation and Installation
Figure 2-26 Temp Mount: Securing the coupler
Figure 2-27 Temporary Mount: Install sensor
carrier/knuckle onto 24" pipe
2-24
6. Position the coupler over the center of the flow stream and
tighten the coupler bolts on the back and bottom.
Tighten coupler
bolts (2)
7. Remove the end caps from the 24" pipe and slide one end
through the knuckle on the sensor carrier.
8. Reinstall the cap on the bottom end. Turn the assembly
top-side up and slide the knuckle down to rest on the bot-
tom cap.
Advertisement
Table of Contents
