Table of Contents
Advertisement
TIENet™ 360 LaserFlow™
Velocity Sensor
Section 4 Setup with 2160 LaserFlow Module
4.1 Activating Connected
Sensors
Figure 4-1 Activate connected sensors in Flowlink
The LaserFlow sensor is compatible with both the Teledyne Isco
2160 LaserFlow Module and the Teledyne Isco Signature Flow
Meter. For Signature setup instructions, refer to Section 3.
The 2160 module is programmed and set up using Teledyne Isco
Flowlink® software. This section of the manual describes acti-
vation of connected sensors, and basic LaserFlow and optional
TIENet 350 level and velocity measurement setup.
This section of the manual assumes the 2160 site is already con-
figured in Flowlink, and the 2160 module is connected to
Flowlink. Detailed Flowlink instructions are available in the
Flowlink Windows Help and also in the Flowlink software user
manual. For complete information about the 2160 LaserFlow
Module, refer to the 2160 LaserFlow Module Installation and
Operation Guide.
To add an available (connected) LaserFlow sensor or optional 350
AV sensor and to activate in Flowlink, select the TIENet tab
(Figure 4-1), then highlight the appropriate LaserFlow module
2160 module, and click the "Configure" button.
4-1
Advertisement
Table of Contents
