Table of Contents
Advertisement
Shield
Braid-Drain
Figure 2-4 TIENet Device terminal connections
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 2 Preparation and Installation
3. Feed the TIENet device cable end through the sealing nut
and seal and through the cable nut. Lightly tighten the
sealing nut, just enough to hold the cable in place while
installing the connector.
4. Attach the wire ends to the terminal strip as shown in
Figure 2-4), then press the terminal strip back down into
its socket on the case board, as shown in Figure 2-5, ensur-
ing no wire connections are strained. Gently tug each wire
when finished, to verify secure connection to the screw ter-
minals.
Note
The SHIELD wire is the bare drain emerging from the foil
s h i e l d a r o u n d t h e YE L L OW a n d B ROW N w i r e s. T h e
BRAID-DRAIN wire is the bare drain emerging from the sur-
rounding braided shield inside the cable jacket. It is not neces-
sary to prevent the two braids from coming into contact with
each other.
2-5
Advertisement
Table of Contents
