Velocity Grid - Teledyne TIENet LaserFlow 360 Installation And Operation Manual

3.3 360 Velocity Grid

Figure 3-9 360 Velocity grid
The 360 Velocity screen has a grid containing 15 possible mea-
surement points. Use the Shortcuts > Adjust function to navigate
to this screen (refer to Figure 3-9).
The measurement points are activated and deactivated with the
arrow and Enter keys. To save the measurement settings, high-
light Update and press Enter.
As the LaserFlow begins to take readings, the grid becomes pop-
ulated with a velocity reading and time stamp for each active
measurement point (points where a valid reading could not be
obtained will display the word "invalid").
Prior to operation, the LaserFlow sensor must be set up for mea-
surement using the 360 Velocity grid. Refer to Section 3.4.
Configure Options
1. Site Setup
2. Measurement Setup
3. Adjust
4. Equation/Trigger Setup
360 Velocity
Laser On Laser Off
Measurements are displayed in [UOM].
0.80
7/17/12
3:31:18PM
TIENet™ 360 LaserFlow™ Velocity Sensor
Section 3 Setup with Signature® Flow Meter
5. Data Storage/Push Setup
6. Sampler Setup
7. Outputs/Alarms Setup
8. Reset Totalizers
9. Reports/History Setup
Adjust
1. Level
2. Velocity
Adjust Velocity
1. 360 Velocity
Update
1.01 0.97
7/17/12 7/17/12
3:30:27 PM 3:30:44 PM
0.99
7/17/12
3:31:52PM
0.91
7/17/12
3:31:01 PM
0.72
7/17/12
3:33:35 PM
3-13