Table of Contents
Advertisement
2.7.2 Offset Carrier from
Cargo Bar
Figure 2-31 Temporary Mount: Optional elbow pipe for
offset
TIENet™ 360 LaserFlow™ Velocity Sensor
14. Using the bubble level on top of the sensor as a guide,
adjust the carrier by loosening the appropriate bolts in the
sensor carrier clamp such that the bubble in the level falls
within the concentric rings.
15. Turn the laser on to make final adjustments so that the
laser beam hits the flow stream at the exact center of the
pipe (refer to Section 3.4 for Signature or Section 4.3 for
2160).
16. Following final adjustments, ensure that all mounting
bracket fasteners are tightened.
For installations where the temporary mount assembly alone
cannot suspend the sensor directly over the center of the flow, an
optional elbow pipe is available to create an offset of 6" from the
cargo arm.
Simply install it between the 24" pipe and the knuckle, as shown
below.
Section 2 Preparation and Installation
2-27
Advertisement
Table of Contents
