Table of Contents
Advertisement
TIENet™ 360 LaserFlow™
Velocity Sensor
Section 3 Setup with Signature® Flow Meter
3.1 Configuring the
System
3.1.1 Updating the Device
List
360 Distance –
Distance between the bottom of the
sensor and the surface of the flow stream (refer to
Section 3.2.2).
360 Velocity –
Average velocity of the flow stream
360 Laser Temperature –
laser assembly
360 Y-Axis –
Tilt about the 'y' axis (pitch)
360 Ultrasonic Signal –
return echo
360 Sense Voltage –
M e a s u r e m e n t o f w i n d o w
clarity (under 100 mV) –
360 Doppler Power –
pler signal for velocity
The LaserFlow velocity sensor is compatible with both the
Teledyne Isco Signature Flow Meter and the Teledyne Isco 2160
LaserFlow Module. For 2160 setup instructions, refer to
Section 4. For complete information about the Signature Flow
Meter, refer to the Signature Flow Meter user manual.
To configure the Signature flow meter for operation with the
LaserFlow sensor, press the "Menu" button (
top menu, and then select "Hardware Setup". For all TIENet
devices including the LaserFlow sensor, select "Smart Sensor
Setup (TIENet)".
When the LaserFlow sensor has been physically added to the
system, select "Perform Scan" so that the flow meter detects it.
When the scan is complete, the LaserFlow sensor (model number
360) appears in the list of connected devices, ready to be con-
figured with the steps shown in Figure 3-2.
Note
From the Hardware Setup menu, "Configure Measurements"
refers to defining and selecting the parameters for each con-
nected device.
The LaserFlow sensor parameters are:
Temperature of the
Strength of the ultrasonic
Strength of the laser Dop-
360 Level –
Level of the flow stream surface
360 Case Temperature –
LaserFlow sensor housing
360 X-Axis –
Tilt about the 'x' axis (roll)
360 Laser Diode Current –
diode
360 Temperature –
Temperature of the window
360 Air Temperature –
(ambient) air
360 Window Temp –
Temperature of the window
) to access the
Internal temperature of the
Current draw of the laser
Temperature of surrounding
3-1
Advertisement
Table of Contents
