Power Apss And Trusted Platform Module Card; Removing The Power Apss And Trusted Platform Module Card - IBM 9080-M9S Manual

Power APSS and trusted platform module card

Removing the Power APSS and TPM card from the 9080-M9S system node
To remove the Power APSS and trusted platform module (TPM) card, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the Power APSS and TPM card.
Note: Be careful not to damage the identification LED activation button as you complete these steps.
a) Unlock the levers (A) to release the Power APSS and TPM card from its connector. Refer to the
following image.
b) Rotate the levers in the direction shown.
c) While holding the Power APSS and TPM card by its levers, pull upward to remove the card from its
slot.