IBM 9080-M9S Manual page 728

a) In the navigation area, expand System Configuration > Program Vital Product Data.
b) Click System Brand.
Note: If you do not know the correct system brand, contact your next level of support.
c) Verify the system brand matches what you recorded previously. If the system brand does not
match what you previously recorded, contact your next level of support.
d) Click System Keywords.
Note: If you do not know the system unique ID, contact your next level of support. You cannot boot
the system until valid values are entered for all fields. You can change these entries only once.
e) If the system keywords match what you recorded previously, click Save settings. Otherwise, enter
the values for the machine type, model number, system serial number, system unique ID, and RB
Keyword, then click Save settings to update the system keywords and to save them to the VPD.
f) In the ASMI navigation panel, expand Power/Restart Control > Power On/Off System. Then, click
Save settings and power on.
g) In the ASMI navigation panel, expand On demand Utilities > CoD Activation. Enter the CoD and
VET activation codes that you obtained from IBM for this new VPD card. Then, click Continue to
write the codes to the VPD card for each CoD and VET code that you have.
9. Verify the installed part.
• If you replaced the part because of a service action, verify the installed part. For instructions, see
Verifying a repair (www.ibm.com/support/knowledgecenter/POWER9/p9ect/
pxect_verifyrepair.htm).
• If you installed the part for any other reason, verify the installed part. For instructions, see Verifying
the installed part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm).
722 Power Systems: Removing and replacing parts in the 9080-M9S system