IBM 9080-M9S Manual page 66

Table 7. USB Cabling
From
ND1 or ND2: P1-C13-T3
3. Plug the USB cable into the previously identified location in the system node by inserting the cable into
the connector, as shown in the following figure.
Figure 54. Replacing the USB cable into the system node
4. Plug the USB cable into the previously identified location in the system control unit by inserting the
cable into the connector, as shown in the following figure.
60 Power Systems: Removing and replacing parts in the 9080-M9S system
To
SC1: P1-T1