IBM 9080-M9S Manual page 661

Figure 575. Removing dust and debris from the system processor socket
b) Hold the sides of the tool with system processor module and carefully lift the tool out of the system
processor module tray.
c) Lower the tool and system processor module onto the socket. Align the beveled corner of the tool
with the beveled corner on the socket. Align the guide pins (A) with the alignment holes (B) on each
side of the tool. Use care to lower the tool evenly without tilting the tool.
See Figure 576 on page 656.
Note: Do not attempt to slide the tool and the system processor module in any direction while the
system processor module is touching the socket. If the tool and the system processor module are
not aligned with the guide pins, lift the tool and the system processor module and reposition them.
System processor module 655