IBM 9080-M9S Manual page 566

Table 60. Service processor (FSP) cable locations
Drawer
ND4 (top)
ND3
ND2
ND1 (bottom)
7. Review the following information to identify the locations where the USB cable connects to the
system node that you are servicing and to the system control unit. Then, reconnect the USB cable
that you removed.
Figure 486. USB Cabling
Table 61. USB Cabling
From
ND1 or ND2: P1-C13-T3
a) Plug the USB cable into the previously identified location in the system node by inserting the cable
into the connector, as shown in the following figure.
560 Power Systems: Removing and replacing parts in the 9080-M9S system
Cable Cable Length
A 1330 mm (4.36 ft) SC1-P1-T7
B 1330 mm (4.36 ft) SC1-P1-T9
A 1110 mm (3.64 ft) SC1-P1-T6
B 1110 mm (3.64 ft) SC1-P1-T8
A 855 mm (2.81 ft)
B 855 mm (2.81 ft)
A 355 mm (1.16 ft)
B 355 mm (1.16 ft)
From
SC1-P1-T2
SC1-P1-T4
SC1-P1-T3
SC1-P1-T5
To
SC1: P1-T1
To
ND4-P1-C9-T2
ND4-P1-C10-T2
ND3-P1-C9-T2
ND3-P1-C10-T2
ND2-P1-C9-T2
ND2-P1-C10-T2
ND1-P1-C9-T2
ND1-P1-C10-T2