Printronix ProLine 5 Series Manual page 88

Error markers
Enable prints the following error markers for those elements that print beyond the
page boundaries:
>> for elements that begin off the right side of the page;
<< for elements that begin at the indicated position but end off the page;
for elements where the starting position of the command contains
an error other than an off-page error.
Offpage Errors
When enabled, reports errors for elements that start or end beyond the right edge
of the page. When disabled, does not report these errors.
Barcode Errors
When enabled, an error message will print when invalid bar code data is
encountered. When disabled, VGL will not print an error for illegal bar code data;
the bar code will be skipped.
NOTE: When bar code error is disabled, VGL emulation will try to make the
best use of invalid data by either truncating extra digits or adding
zeros to the end of bar code data to meet minimum data length
requirements for some bar codes. Not all errors will be corrected.
Ignore / DB8 Setup
Determines if character filtering is enabled, or if one or both characters are
ignored.
DISABLE. Character filtering is not enabled.
Char 1. Character 1 will be filtered. Select the option Ignore ch#1 to
specify character 1.
Char 2. Character 2 will be filtered. Select the option Ignore ch#2 to
specify character 2.
Char 1&2. Characters 1 & 2 will be filtered. Select the options "Ignore
ch#1" and "Ignore ch#2" to specify values for these characters.
Configuration Menus 4–35