Printronix ProLine 5 Series Manual page 111

Printer Type
Determines the SPC Twinax emulation 'Mode'. Set to Std Centronics, IGP/VGL,
or IGP/PGL, the SET LINE DENSITY and SET PRINT DENSITY commands are
translated into a Carriage Return (CR) only and vertical format commands are
ignored unless the EVFU is enabled.
SFCC Char
Determines what character is printed when an EBCIDIC LOGICAL NOT
character Hex 5F) is received from the host.
EVFU
When enabled, the EVFU parameter allows vertical format control by the host in
all four printer type modes. When disabled, vertical format control is only allowed
in IMPACT/P–SERIES mode.
SPC Char Set
Allows you to select the print language character set.
Translation Table
TRANSLATION TABLE prints out a table of the twinax interface's current
character set. This operation is valid only when the twinax interface is selected.
Buffer Print
When enabled, the BUFFER PRINT parameter prints the EBCDIC data and
control codes received from the host as hex values. The output can be used to
troubleshoot printer data reception problems. Refer to Chapter 6 for information
on how to obtain a hex code printout.
4–58 Configuration Menus