Printronix ProLine 5 Series Manual page 126

Define LF Code
This option determines whether an automatic carriage return should occur
whenever a line feed command is received.
LF = LF does not perform an automatic carriage return. The next print
position will be the current print position of the next line.
LF = CR + LF forces an automatic carriage return with each line feed
command. The next print position will be position 1 of the next line.
Printer Select
This option determines if the ASCII DC1 and DC3 control codes can be used to
disable and enable the printer.
DISABLE ignores the DC1 and DC3 control codes.
ENABLE disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alternate Set 80–9F
This option determines if data in the range of hex 80 through hex 9F should be
interpreted as a control code or as a printable character.
CONTROL CODE interprets data in the range of hex 80 through hex 9F
as a control code.
PRINTABLE prints data in the range of hex 80 through hex 9F.
Character Set
You can specify IBM PC, Multinational, ECMA Latin 1, DEC Multinational,
OCR–A, or OCR–B as the character set under Serial Matrix. As
shows, several language and special character set choices are available as
submenu options under IBM PC, Multinational, ECMA Latin 1, and DEC
Multinational. IBM PC with ASCII (USA) as the Primary Subset and with Code
Page 437 as the Extended Subset is the default character set.
Configuration Menus
page 4–75
4–73