Printing A Job In Manual Mode On Jeti Tauro H3300Led - AGFA Jeti Tauro H3300LED Series Operator's Manual

Printing a job in Manual Mode on Jeti Tauro H3300LED

Follow this procedure to print in manual mode on the Jeti Tauro H3300LED printer.
Procedure 5-2: How to Print a Job in Manual Mode
- Step 1: Unload the previous mode configuration, select the manual configuration from the system
pane
(outlined in red in Fig.5-15)
Output Modes on the
- Step 2: Select the job to print from the job list pane Ready tab and number of copies
.
Fig.5-16)
- Step 3: Check the job settings in the Layout details pane (outlined in green in Fig.) and the media
thickness
(outlined in blue in Fig.5-16)
- Step 4: Check the media position indicated in the layout preview
in this case).
Agfa Graphics
and press the load button
Tauro.
adjust the copies if needed
Revision 1.0
Jeti Tauro H3300LED Operator Manual
(outlined in green in Fig.5-15)
Fig.5-15: System Window - Manual Mode
(outlined in yellow in Fig.5-16)
(outlined in magenta in Fig.5-16)
Fig.5-16: Job List Window - Manual Mode
. Refer to Input and
(outlined in red in
.
(0 mm
Chapter 5
48