AGFA Jeti Tauro H3300LED Series Operator's Manual page 101

From the General tab, the operator can:
• Modify the Head Gap.*
- allows trimming the distance between the print heads and the media by steps of 0.01mm.
• Adjust transport movement.
- The Transport Adjust area allows the option to fine-tune the media drive belt step movement
during the print process.
• Enable unidirectional printing
- The Unidirectional printing check box allows the selection of unidirectional printing. By default,
the Jeti Tauro H3300 LED performs bidirectional printing.
• Activate the anti-static devices.**
- The Anti-static devices activation check box allows the activation of the anti-static devices while
printing the selected lay out.
• Adjust the UV settings and ***
- The UV Leading and the UV Trailing sliders (outlined in magenta in Fig.6-38) provide control over
the UV curing light intensity in a range from minimum value 10% to 100%. Checking, the off box
turns the UV curing power OFF.
• Turn Shuttle Outside Of 'pull down menu' allows the control over the UV curing light during printing.
- Image mode is selected, the shuttle travel is limited to the image width
- Media mode is selected, the shuttle travel is limited to the media width, default setting.
- Table mode is selected, the shuttle travels over the entire media transport belt.
• set the number of copies for the selected layout.
* Caution: Improper use of Head gap command may significantly degrade the print quality.
** Note: Some media accumulates electro static charges. These electro static charges
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
Revision 1.0
Fig.6-38 PrintTask Pane General Tab
Chapter 6
93