AGFA Jeti Tauro H3300LED Series Operator's Manual page 55

- Step 4: Navigate to the Quality Tab and check the Mask setting
the General Tab and check the Transport adjust
es a significant step fault, you can trim the Transport Adjust. The Mask setting is mainly applied while printing
a solid tint to cover some artifact on the image.
- Step 5: Navigate to the Densities Tab and check if the Densities
white and primer are defined by the used CPM.
Note: The value is set by default to 100% on the GUI. It is possible to change the densities to insure
a proper opacity for the white or to reach a higher density for the colors or to reach a higher ink ad-
hesion on the media. Modifying these settings can influence the print result.
- Step 6: Navigate to the Quality Tab and check that the number of passes (outlined in blue in
is linked to a CPM and to a quality mode.
Note: It is possible to change the number of passes, but this can influence the speed and the print
quality.
- Step 7: Proceed to the appropriate printing mode for the print job:
• "Printing a job in Manual Mode on Jeti Tauro H3300LED"
"Printing a job in Continuous Mode on Jeti Tauro H3300LED"
•
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
(outlined in blue in Fig.5-12)
Revision 1.0
Fig.5-12: General Tab
(outlined in green in Fig.5-13)
. When the media drive belt produc-
Fig.5-13: Quality Tab
(outlined in red in Fig.5-14)
Fig.5-14: Densities Tab
and then to
for color,
Fig.5-13)
Chapter 5
47