AGFA Jeti Tauro H3300LED Series Operator's Manual page 61

Jeti Tauro H3300LED Operator Manual
Note: On its path, the flattening roll will push down the board. The board travels
further and after a pre-scan, the shuttle starts printing. The pinch roll bar goes
up again when it reaches the trailing edge of the board. The media set bar
comes down again once the board has traveled completely underneath. This
happens automatically based on the media dimensions filled out in Asanti.
The set bar
goes up
Belt transport
the board
The Pinch roll bar comes
down
Fig.5-25: First Board Loaded - Manual Continuous Mode
- Step 5: Load the next board following the same steps as for the first board.
First board
Next board
Fig.5-26: Next Board Loaded - Manual Continuous Mode
Note: On the Media Output side, the boards come out with a small gap in between.
Gap first
and next
board
Fig.5-27: Board on Output Side - Manual Continuous Mode
Agfa Graphics Revision 1.0
Chapter 5
53