Pedals - AGFA Jeti Tauro H3300LED Series Operator's Manual

Pedals

The Jeti Tauro H3300 LED features three pedals on the Media Input side and three pedals on the output
side, both with identical functions. These pedals duplicate GUI controls over the printer in order to ease
the loading process.
- The functions of the pedals differ depending on the status of the printer. The conditions shown in
Table Gui controls, apply for each table.
Table Gui controls
GUI Controls:
Status
Ready
Preparing
Printing
Agfa Graphics
Left pedal
Turns vacuum on/off - Transports the me-
Turns vacuum on/off Slot 2: Up/down
Disabled
Revision 1.0
Jeti Tauro H3300LED Operator Manual
Control pedal
dia drive belt toward
- Press this pedal a
second time to stop
the belt
- Continued pressure
on the pedal is mov-
ing the belt until you
lift your foot
movement in manual
sheet mode
Disabled
Fig.3-3: Pedal GUI Controls
Right Pedal
- Transports the media
drive belt backward
- Press this pedal a
second time to stop the
belt
- Continued pressure
on the pedal is moving
the belt until you lift
your foot
Print start
Disabled
Chapter 3
Fig.3-2: Pedals
17