- Step 4: When the Service Host window is closed, you can safely turn OFF the printer from the main
switch
(see Fig.4-1: E-stop Button Location and Power Switch)
Caution: The printer should always be plugged to the electrical cabinet, even if the printer is
powered down from its main switch.
In case the printer is not connected:
- White ink circulation stops and white heads might get clogged.
- Heads will start dripping after 6 hours (internal battery will be down
Zero point cal
Note: After changing manual mode to RTR, Zero point calibration must be performed (Customer
Service Responsible).
Important: The test will only be performed if the right mode configuration is selected and
loaded. Log in as Key Operator
3
2
- Step 01: Print and check the nozzle test pattern for colors, white and primer
check). Technical images are located under the filter icon.
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
1
Revision 1.0
Fig.4-28: Zero Point Calibration Window
(see Perform Nozzle
Chapter 4
38