Replacing The Management Ethernet Cable On The M120 Routing Engine; Figure 81: M120 Routing Engine Interface Ports And Alarm Relay Contacts - Juniper M120 Hardware Manual

M120 Multiservice Edge Router Hardware Guide
Related
Documentation

Replacing the Management Ethernet Cable on the M120 Routing Engine

210
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Plug the other end of the cable into the device's serial port.
2.

Figure 81: M120 Routing Engine Interface Ports and Alarm Relay Contacts

Connecting the M120 Router to an External Alarm-Reporting Device on page 158
Preventing Electrostatic Discharge Damage to an M120 Router on page 316
M120 Routing Engine Interface Ports and Status Indicators on page 28
For cable specifications, see
the M120 Router" on page
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 77 on page 206
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
Figure 78 on page 207 shows the external device ports on the craft interface. The ports
labeled connect to the Routing Engine in the left Routing Engine slot (
0
ports labeled 1 connect to the Routing Engine in the right Routing Engine slot (
Plug the other end of the cable into the network device.
4.
"Routing Engine Interface Cable and Wire Specifications for
105. To replace the management Ethernet Cable:
shows the connector.
ETHERNET
port.
ETHERNET
), and the
RE0
Copyright © 2018, Juniper Networks, Inc.
RE1 ).