Replacing An M120 Xenpak Module; Removing An M120 Xenpak Module - Juniper M120 Hardware Manual

Related
Documentation

Replacing an M120 XENPAK Module

Removing an M120 XENPAK Module

Copyright © 2018, Juniper Networks, Inc.
M120 PICs Description on page 57
Connecting PIC Cables to the M120 Router on page 164
Maintaining M120 PICs and PIC Cables on page 275
XENPAK modules are optical transceivers that can be removed from a PIC (for more
information, see "M120 PICs Description" on page
XENPAK modules are hot-insertable and hot-removable. Removing a XENPAK module
does not interrupt PIC functioning, but the removed module no longer receives or transmits
data. To replace a XENPAK module, perform the following procedures:
Removing an M120 XENPAK Module on page 231
Installing an M120 XENPAK Module on page 232
To remove a XENPAK module (see
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
1.
XENPAK module. Have ready a rubber safety cap for the XENPAK transceiver and the
cable.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Label the cable connected to the XENPAK module so that you can later reconnect it
3.
to the correct module.
Disconnect the cable from the XENPAK module. Immediately cover the transceiver
4.
and the end of the cable with a rubber safety cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Arrange the cable in the cable management system to prevent it from dislodging or
5.
developing stress points. Secure the cable so that it is not supporting its own weight
Chapter 27: Replacing Line Card Components
57).
Figure 92 on page 232):
231