Figure 97: Installing An M120 Ac Power Supply - Juniper M120 Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
NOTE: Each AC power supply has two AC appliance inlets. Each power
supply must be connected to a dedicated AC power feed. For 100-120
VAC, both inlets are used. For 200-240 VAC, only the top inlet is used. For
information about site power preparations, see
Requirements" on page
to power and ground, see
Router" on page
Switch the power switch on the power supply faceplate to the on position (
13.
that the status LED on the power supply faceplate blinks, then lights steadily
approximately one minute after you switch on the power switch.

Figure 97: Installing an M120 AC Power Supply

M120 AC Power Supply Description on page 72
Maintaining the M120 Power Supplies on page 277
Electrical Specifications for the M120 AC Power Supply on page 95
Removing an M120 AC Power Supply on page 239
Chapter 28: Replacing Power System Components
88. For information about connecting the router
"Connecting Power to an AC-Powered M120
167.
"M120 Router Power
). Verify
|
243